Taylor-wharton XL-240 Manuel d'utilisateur télécharger pdf (Page 14)

Lower the assembly about 4 in. (102 mm) slowly and try to keep the rod in the center of

the threaded entrance hole as you do. If you are careful during this portion of the inser-

tion, you will drop the float rod straight though the guide ring inside the cylinder.

1. To confirm that the rod is correctly positioned in the cylinder, stop where you can

still grasp the top of the rod (see illustration) and try to swing the lower end from

side to side.

2. When the rod is engaged in the guide ring, the rod will be restricted to lower end

movement of about ½ in. (12.7 mm); if you can feel greater movement, withdraw

the rod to the point where its top is 8 in. (203 mm) above the gauge opening and try

again.

3. When you are satisfied that the float rod is correctly installed, lower the rest of the

way into the container until the top portion threads can be engaged.

4. Screw the gauge in place and hand torque to about 20 ft. lbf (2.8 kgf m). Leak check

the connection of gauge body to the flange.

CAUTION:

When installing the gauge assem-

bly, care must be taken to ensure

that the float rod is inserted through

“guide ring” located on the liquid

withdrawal line inside container. IF

gauge does not engage this ring, the

contents indication will be inaccu-

rate, or the gauge may be damaged

in use.

Contents Gauge Insertion

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Taylor-wharton XL-240 Manuel d'utilisateur Page 14