Taylor-wharton XL-240 Manuel d'utilisateur télécharger pdf (Page 9)

In use, the CGA end fitting on the Fill/Vent Tee Assembly couples to the fill connection

to be filled. The Relief Valve vents pressure over 350 psig (24-bar/2413 kPa) that builds

up in the fill line due to trapped liquid. The Dump Valve is used to allow the operator to

blow-down in the receiving container during a pump fill, or to relieve residual pressure

from expanding liquid trapped before disconnecting the fill line.

Fill kits are available with different combinations of hose length. The following chart

identifies the available transfer hoses and the Fill/Vent Tee assemblies that are appro-

priate for use with the XL-160/XL-180.

Transfer Hoses & FILL/VENT Tee Assemblies

The Fill/Vent Tee connects to a transfer hose to complete a fill line kit. Each assembly

includes a 3/8-in. pipe connector to CGA fitting with a 350-psig (24-bar/2413-kPa) relief

valve, and a ball-type dump valve.

Description Cylinder

Connections

End

Fittings

Part

Number

Hose, 4 ft. (1.2 m) SS LIQUID or VENT valve CGA 295 to 3/8 in NPT 1700-9C65

Hose, 6 ft. (1.8 m) SS LIQUID or VENT valve CGA 295 to 3/8 in NPT 1600-9C66

Fill/Vent Tee Assemb. LIQUID or VENT valve CGA 295 GL50-8C60

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Taylor-wharton XL-240 Manuel d'utilisateur Page 9